ASE B4 Domain 3: Stationary Glass Welcome to your ASE B4 Domain 3: Stationary Glass 1. ASE B4: Stationary Glass What is the primary purpose of using a primer on the pinch weld before installing a new windshield? A. To improve the aesthetic look of the installation B. To protect the metal from corrosion C. To enhance the grip of the adhesive D. To fill any minor imperfections in the metal None 2. ASE B4: Stationary Glass When replacing a windshield, what type of adhesive is recommended for bonding the glass to the vehicle body? A. Silicone-based adhesive B. Polyurethane adhesive C. Epoxy adhesive D. Acrylic adhesive None 3. ASE B4: Stationary Glass Why is it important to use manufacturer-recommended setting blocks when installing stationary glass? A. To maintain proper alignment of the glass B. To prevent vibration and noise C. For ease of installation D. To ensure uniform distribution of the adhesive None 4. ASE B4: Stationary Glass What is the main risk associated with using an excessive amount of urethane adhesive when installing a windshield? A. Increased installation time B. Reduced visibility through the glass C. Distortion of the glass D. Weakening of the adhesive bond None 5. ASE B4: Stationary Glass What is the primary concern when removing a windshield that will be reused? A. Keeping the windshield clean B. Preventing damage to the paint around the windshield C. Avoiding scratches on the glass surface D. Not breaking the windshield during removal None 6. ASE B4: Stationary Glass What is the purpose of using a damming foam during stationary glass installation? A. To insulate against temperature changes B. To control the flow and thickness of the adhesive C. To prevent water from entering the vehicle D. To reduce noise transmission through the glass None 7. ASE B4: Stationary Glass In terms of safety, why is it crucial to follow the specified drive-away time after windshield replacement? A. To allow the adhesive to fully cure for maximum strength B. To prevent the glass from moving out of alignment C. To allow the vehicle owner to inspect the installation D. To avoid immediate exposure to environmental elements None 8. ASE B4: Stationary Glass When installing a new rear window, the technician must ensure: A. The defroster grid lines are aligned horizontally B. There is no contact between the glass and the vehicle body C. The window tint matches the rest of the vehicle D. The window is centered within the opening None 9. ASE B4: Stationary Glass What is a critical factor to consider when working with laminated side glass? A. The color of the interlayer film B. The orientation of the glass layers C. The thickness of the glass D. The type of adhesive used for lamination None 10. ASE B4: Stationary Glass Why is it important to clean the edges of the stationary glass before installation? A. To ensure a glossy appearance B. To facilitate easier handling C. To allow the adhesive to bond properly D. To prevent water streaks after installation None 1 out of 10 Time is Up! Time's up
